Filter
Top Products
English
Chapter 2 - Windows Setup 27
USB interface
Note:
No USB interface cable is supplied with the
printer. Please use a USB interface cable that is
compatible with USB specification 1.1.
General
A USB interface has the following restrictions:
• Will not operate using a MS-DOS or Windows
95/3.1/NT 4.0/NT 3.51 operating system.
• Will not operate using a Windows 98 operating
system that has been upgraded from a Windows
95/3.1 operating system.
• Do not disconnect the USB interface cable during
printing.
• Do not immediately disconnect and connect the
USB cable or vice versa. Wait at least 5 seconds
before re-connecting or disconnecting the cable.
• The operation of a printer is not assured if a USB
compatible device is connected concurrently with
other USB-compatible machines.
• When connecting multiple printers of the same
type, they appear in the print folder as *****,
***** (copy2), ***** (copy3), etc. These
numbers depend on the order of connecting or
turning on each printer.
• If a USB hub is used, it is necessary to connect
the USB hub directly to the computer.
Connection
1. Make sure the printer and computer are turned
off.
2. Connect the USB interface cable into the USB
port on the computer.
3. Connnect the other end of the USB interface
cable to the USB connector on the printer.
4. Turn the printer on, then turn the computer on.
9000GBS.book Page 27 Wednesday, December 6, 2000 10:07 AM