Filter
Top Products
English
Chapter 2 - Windows Setup 37
Network connection
Note 1:
An optional Ethernet network interface card
(NIC) is needed for connection to a network. For
information on installing a network interface
card, refer to Chapter 8 Optional Accessories.
Note 2:
Administrator’s authority is required when
installing using a network connection.
1. Confirm that the power is off to the printer.
2. Connect a network interface cable (twisted pair)
into the NIC socket in the printer.
3. Connect the other end of the network interface
cable into the network socket.
4. Switch on the printer.
5. Install the printer driver using the Add Printer
Wizard and configure the printer driver to the
network port the printer is connected to.
6. For further details on how to configure network
connection, refer to the relevant section in the
user’s guide for the network interface card.
Internal hard disk
If your printer includes the hard disk, please use the
following procedure to make sure that the hard disk has
been enabled in the printer and printer driver.
Printer
1. Print a Menu Map as follows to confirm the hard
disk is correctly installed.
(a) Press
Menu (0)
button twice to access the
INFORMATION MENU.
(b) Press
Select (3)
button and confirm PRINT
MENU MAP is displayed on the LCD.
(c) Press
Select (3)
button to print the menu
map.
(d) Check that HDD now shows installed in the
printer.
2. After installation, the hard disk has to be
initialised as follows:
(a) Press
Menu (0)
button until DISK
MAINTENANCE is displayed, then press
Select (3)
button.
9000GBS.book Page 37 Wednesday, December 6, 2000 10:07 AM