Filter
Top Products
46 OkiLAN 3100e Network Card
Telnet provides the following commands: • After the settings are made with the set
command, they become valid when you log out
the Telnet.
• The kill command severs the connection with the
Connection No that has been specified with N of
“kill N”. The executed command becomes valid
when this command ends.
• The reset command forcefully severs all the
connections that are currently connected and
initializes. This command becomes valid when
you log out the Telnet. The execution of this
command affects the use of this network card
significantly. Therefore, exercise caution in
executing this command.
Next, the operation procedure of the Telnet Client is
explained. Here, an example is given in which Telnet is
SNMP
SystemContact Own contact name 1 - 47characters. Default: Blank
SystemName Own name information 1 - 47characters. Default: Blank
SystemLocation Own location information 1 - 47characters. Default: Blank
Trap Community Set strings to set to trapmessage 1 - 32characters. Default: Public
Trap Destination Trap destinationaddress 1 - 6 Destinations
Trap Usage Trap Enable/Disable ENABLE/DISABLE
Trapevents Set the events to set to Trap message
ON-LINE/OFF-LINE/Paper Out/Paper Jam/Cover
Open/Printer error
Category Item Meaning Range
Command Abbreviation Meaning Restrictions
show address shaddr Display all addresses
show connection shconn Display all connections
show queue shq/lpq Display print queue
show status shstat Display status
show protocol shpro Display protocol setting
set address seaddr All address settings root only
set address ip seaddr ip IP address setting root only
set address mask seaddr mask Subnet mask setting root only
set address gateway seaddr gate Gateway setting root only
set protocol sepro Protocol info setting root only
switchuser su Switch user
kill kill Kill connection root only
reset reset reset connection rootonly
help help Display command help
quit logout/exit Exit from Telnet
3100euGB.book Page 46 Friday, March 16, 2001 1:18 PM