Filter
Top Products
2.1.4.3 Disassembly Instruction
If necessary, the board assembly may be removed from the front of the case
housing.
Warning: Disconnect ac power from the unit before proceeding.
1. Remove the board assembly from the case by pulling at the sides of the bezel.
2. The bezel, along with the board assembly will unlatch from the case housing.
•
Depending on the size of your Ethernet connector, you may need to
disconnect it from the RJ45 jack on the rear of the meter.
•
Depending on the length of your antenna cable, you may need to
disconnect it from the rear of the meter.
Figure 2.6 Accessing the Main Board Assembly
Gasket
10