Filter
Top Products
4.3.6 Controller Setup
The Meter has two modes of operations. One is through the Front Panel Buttons
(please refer to Front Panel Supplement for more details), and the other is by
using the browser to configure the settings. Click on from the Home
Page. In a few seconds the following page will appear.
Figure 4.13a Controller Setup
Channel 12
Please refer to local regulation for maximum transmit power range
Transmit Power Range
Reset
PID 13106 (version x.x)
iSeries Firmware Version x.x
End Dev
i
c
e ID -
Input
Setpoints & On/Off
Alarm 2
Alarm 1
Loop Break
Passcode ID
Display
Permanent Store
Enable Standby Mode Before Configuring Unit
Scrolling
Main Menu
CONTROLLER SETUP
Setup
Transmit Power
Misc.
Monitor
C
ONTROLLER SETUP
http://192.168.1.200Address
Update
Update
Update
20dBm
Controller
36
A
B
C
D