Filter
Top Products
4.3.9.1 End Device Parameters (continued)
Offset: If it’s determined that the readings are slightly off, the user can manually
assign numerical values to adjust the readings for temperature. The unit must be
in degree C.
Display: To enable or disable numerical display on the Meter’s Front Panel. By
default, the box is checked (enabled).
Alarm: To enable or disable alarms for that particular sensor. By default, the box
is checked (enabled).
Sensor 2
This is the field to modify the parameters for the internal sensor (ambient).
Update: Saves changes
Cancel: Ignores all the changes and goes back to the “End Device Setup” page.
Reset Device: Reset the End Device’s readings and status. Its data will be
cleared immediately.
4.3.10 Access Control
This section describes the "Access Control" page of the Wireless System Web
interface. This page allows the users to set up the network and security
parameters of the Wireless System.
At the initial entrance to the “Access Control” page you may be prompted for the
LOGIN Password (see Figure 4.6) prior to an ADMINISTRATOR Password.
Figure 4.25 Access Control
ACCESS CONTROL
ACCESS CONTROL
http://192.168.1.200
Address
Main Menu
Login Password 12345678
Admin Password
00000000
IP Address 192.168.1.200
Gateway Address
0.0.0.0
Subnet Mask
255.255.255.0
MAC Address 00:03:03:00:21:D9
Host Name wis21d9
Save Reset
Network Reset
58