Filter
Top Products
28
P
P
r
r
i
i
n
n
t
t
i
i
n
n
g
g
a
a
T
T
e
e
s
s
t
t
P
P
a
a
g
g
e
e
It is now useful to test, if the printer has been correctly installed. For this purpose print the self
test page as follows.
1. Press the ON LINE key while powering the printer on and hold the key pressed until all leds turn
briefly on.
2. Insert a single sheet in A4 or Letter format.
The printer prints the Self-Test page. Check that the printout is correct. The following printout
example shows also the printer setup default values.
S
ELF
T
EST
PS40T:
Code Version Vx.x xxxxxxxx CharGen:xxxxxxxx ver. x.xx
CONFIGURATION SETUP
PROGRAM progr.1 INTERFACE TYPE automatic
PROGRAM LOCKED no INPUT BUFFER 16 Kb
ERROR BUZZER 1 beep IGNORE PE enabled
JOB BUZZER no beep AUTOFEED SIGNAL disabled
SECURITY MODE enabled SLCT-IN SIGNAL disabled
AUTO GAP OFFSET +0.000 mm BUFFER CONTROL XON/XOFF
GET EDGE QUOTE 1/2” ROBUST XON enabled
SKIP PERFORATION disabled WORD LENGTH 8 bit
TEAR ADJUST +0,00 mm BAUD RATE 9600 bps
PARITY BIT none