Filter
Top Products
33
Each printer setup form is identified by a marker in the upper left corner of the page as follows:
Configuration Setup
Program 1
Program 3
Program 2
Program 4
If you press the
LQ
key:
The printing of the printer setup forms starts. The forms are printed according to the selection
made with the
PROGRAM
key.
If you select one of the Program couples P1/P3 or P2/P4 you can define one parameters set for
printing on cut sheets and one for fanfold.
P1
and
P2
define the values for printing on cut sheets,
whereas P3 and P4 define the printing parameters for the fanfold paper.
The program couples may be selected only if the same emulation is selected for the two
programs.
The selection of the Program Setup is made simply by pressing the PROGRAM key. When passing
from one Program Setup to another, the printer resets before setting the parameters as defined in
the new program setup.