Filter
Top Products
36
S
S
e
e
t
t
u
u
p
p
P
P
a
a
r
r
a
a
m
m
e
e
t
t
e
e
r
r
s
s
The following is a listing of the setup parameters.
Configuration Sheet
Setup Parameter Values Description
RESTORE TO MFG no
all
config
prog.1, prog. 2,
prog.3, prog 4
The selected values are not set to factory defaults.
The values set in all printer setups are reset to factory
default values.
The values set in the configuration setup are reset to
factory default values.
The values set in the corresponding program setup are
reset to the factory default values.
PROGRAM progr.1, progr.2, progr.3,
progr.4, progr.1/3,
progr.2/4
Defines the default Program Setup or Setup couple. The
program couples may be selected only if the same
emulation has been selected for the two setups.
PROGRAM
LOCKED
no, yes Locks the program setup selection. In case the lock is
yes
the program setup cannot be changed by pressing the
PROGRAM key.
ERROR BUZZER 1 beep, no beep Selects the behavior of the buzzer in case of an error.
JOB BUZZER no beep, 1 beep,
continuous
Selects the behavior of the buzzer when a new print job is
started: no signal (
no beep
), one beep (
1 beep
) or a
continuous signal (
continuous
).