Filter
Top Products
– 11 –
O
Check the SCSI Channel Interface Definitions.
)
Is the Host Adapter SCSI ID set to “7”?
)
Is the SCSI Parity Checking set to “Enable”?
)
Is the Host Adapter SCSI Termination set to “Automatic”?
SCSI device configuration checks (1)
(Conduct the checks for both channels A and B.)
O
Check the parameters of all the SCSI-ID #0–#15 devices in SCSI
Device Configuration.
(Check that the parameters of all the devices are set as shown below.)
)
Is the Maximum Sync Transfer Rate set to “160”?
)
Is the Initiate Wide Negotiation set to “yes”?
)
Is the Enable Disconnection set to “yes”?
)
Is the Send Start Unit Command set to “yes”?
)
Is the Enable Write Back Cache set to “N/C”?
)
Is the BIOS Multiple LUN Support set to “no”?
)
Is the Include in BIOS Scan set to “yes”?
SCSI device configuration checks (2)
(Conduct the checks for both channels A and B.)
)
Does “Adaptec SCSI Card 39160” appear for SCSI ID #7?
SCSI ID checks
(Conduct the checks for both channels A and B.)
<Check>
<Check>
<Check>