Filter
Top Products
– 29 –
This completes the editing operation checks.
Do not exit the Toolbox since the limited edition of the editing software
program will be used in the next section as well.
After creating the video sequence, check its playback.
The function buttons (see figure at left) at the top of the
sequence editor window are used for the playback
operations.
20. Click the button to move the playback start position to the start of the
video sequence.
21. The playback of the video sequence is started when the button is
clicked.
22. The playback images are output to the video monitor.
23. While the video sequence is being played back, the playback position is
indicated on the video track by the cursor.
24. Playback ends automatically when the end of the video sequence is
reached.
25. To stop the playback at any time, click the button.
26. Click the mark at the top right of the sequence editor window with the
mouse.
27. The window shown below now appears.
28. Click the button to exit the sequence editor.
After checking the editing operations in the video sequence, destroy the
video sequence created.
)
Did the video sequence playback start when the button was
clicked?
)
Did the video sequence playback stop when the button was
clicked?
)
Were the audio and video playback of the video sequence affected by
noise or disturbances?
Check the playback images by viewing the video monitor.
<Check>