Filter
Top Products
– 33 –
)
Did the tape playback at the
a
1 speed start when the button was
clicked?
)
Did the tape playback at the
a
1 speed stop when the button was
clicked?
)
Were the tape’s playback images affected by noise or disturbances?
Check the playback images by viewing the video monitor.
<Check>
7. Click the mark at the far right in the Device list box on the Record To
Video window to display the device list, and select “Internal VTR
(50Mx1).”
8. Operate the internal VTR using the VTR control panel on the Record To
Video window, and return to the approximate point where the
downloaded images start on the tape.
9. Click the button among the VTR controls to play back the internal
VTR’s tape at the
a
1 speed, and check the downloaded data.
10. The playback images are output to the video monitor.
11. To stop playback, click the button.
This now completes the check for the downloading operation and the
downloaded data for the internal VTR’s 50M
a
2 speed mode.
To conduct further checks on the downloading for
O
Internal VTR (50Mx1): Internal VTR 50M
a
1 speed and
O
Internal VTR (25Mx4): Internal VTR 25M
a
4 speed,
select “Internal VTR (50Mx1)” and “Internal VTR (25Mx4)” as the device
displayed on the VTR control panel, and conduct the same checks described
above as for “Internal VTR (50Mx2).”
<Note>
Consult your local dealer regarding installation of the AJ-SF97 non-linear
editing software.