Filter
Top Products
– 12 –
2-3. AV disk inspections
In this section, the AV disks are inspected using the SCSI-BIOS Tool.
These inspections check for defects in the AV disks as recording media. (It
takes about 2 hours to conduct all the inspections in this category.)
1. To return the screen display to the inspection menu selection, press the
[Esc] key several times until the message box shown below is displayed.
2. After selecting [No], press the [Enter] key, follow the displays and return
the device channel (channel A, B) selection screen.
3. Inspect the disks following the instructions on “(3) Inspecting the disk
media” in B-3 (pages 46, 47) of Appendix B (SCSI-BIOS Tool).
Yes
No
Exit Utility ?
Channel A SCSI disk checks
)
Did “Verify Disk” of the SCSI ID #0 disk end with “Disk Verification
Complete”?
)
Did “Verify Disk” of the SCSI ID #1 disk end with “Disk Verification
Complete”?
)
Did “Verify Disk” of the SCSI ID #2 disk end with “Disk Verification
Complete”?
)
Did “Verify Disk” of the SCSI ID #1 disk end with “Disk Verification
Complete”?
)
Did “Verify Disk” of the SCSI ID #2 disk end with “Disk Verification
Complete”?
Channel B SCSI disk checks
4. If all the disks have been inspected with no errors found, refer to B-4
(page 44) in Appendix B, and exit the SCSI-BIOS Tool.
<Check>
<Check>