Panasonic AV-HS400AE Switch User Manual


 
96
5. System settings
Camera control settings
1
Press the [FUNC] button to light its indicator, and press the [SYSTEM] button to display the SYSTEM menu.
2
Turn [F1] to display the CamCTL1 sub menu.
<Menu display>
CamCTL1 Signal CTL Tally
3/16 IN1 1 Disable
IN1-8
1-5
None
Enable
3 Turn [F2] to select the input signal using the Signal item.
4
Turn [F3] to set the control signal (for the camera) that supports the input signal using the CTL item.
Establish the associations between the switching of the cameras linked to the selection of the crosspoint
buttons (PGM/A 1 to 10 and PST/B 1 to 10) and the tally control.
When camer
a control is enabled, the “c” mark appears on the multi view display in front of the names of
the materials in the cameras targeted for control.
When
“P/TDirt” has been selected as the protocol setting, only “1” appears. See 5-6-3.
5
Turn [F4] to enable or disable tally control using the Tally item.
This setting can be selected when “P/TDirt” has been selected as the protocol setting. See
5-6-3.
Enable:
Tally control is enabled.
Red tally signal On/Off control is exercised from the RS-422 interface connector.
Disable:
Tally control is disabled.
6
Turn [F1] to display the CamCTL2 sub menu.
<Menu display>
CamCTL2 Signal PosCont Speed Power
4/16 IN1 PanTilt Fast On
IN1-8
Zm/Focs Middle
Slow
Off
7 Turn [F2] to select the input signal using the Signal item.
8
Turn [F3] to select the control to be exercised by operating the positioner using the PosCont item.
PanTilt:
Panning is controlled by left/right (X) operation; tilting is controlled by up/down (Y) operation.
Zm/Focs:
Lens focusing is controlled by left/right (X) operation; lens zooming is controlled by up/down (Y)
operation.
Each time the rotar
y encoder [Z] is pressed, the PanTilt or Zm/Focs setting is selected alternately.
For controlling the panning
For controlling the lens focusing
For switching between
PanTilt and Zm/Focs
For controlling the tilting
For controlling the lens
zooming
POSITIONER
Z
Control of lens focusing is possible when the
lens focus of the camera is set to manual
operation.
Control using the positioner is possible when
the CamCTL1 sub menu or CamCTL2 sub
menu is displayed.
If the crosspoint buttons (PGM/A 1 to 10 and
PST/B 1 to 10) are held down when “P/TCont”
or “P/TDirt” is selected as the Protcol item
setting, delegation to the CamCTL
2 menu is
initiated.