Filter
Top Products
10
Your computer is equipped with a touchscreen display allowing you to perform the
same operations as the touch pad or mouse by touching the surface of the display with
your finger. (The following explanation gives one example (for the default settings).
The operation settings can be changed in [Start] - [Programs] - [Updd] - [Settings].)
Handling the Touchscreen
Do not place any object on the surface or press down forcefully with sharp-pointed
objects (i.e. nails), hard objects that can leave marks (i.e. pencils and ball point
pen).
Do not apply pressure within 5 mm of the perimeter of the display panel. The
cursor may move to the edge of the display.
Do not operate the computer when such things as dust are on the screen. Do not
allow contact with substances that could dirty the touchscreen, such as oil. The
cursor may not work properly in such cases.
When the touchscreen becomes dirty:
Wipe to remove dirty areas by using a dry soft cloth such as a gauze or soft cloth
first applied with detergent diluted with water and then thoroughly wrung.
Do not use benzene or thinner, or disinfectant-type alcohol.
Moving the cursor
Clicking
Double-clicking
Dragging
Cursor
Touchscreen
CAUTION
The touchscreen function can not be used in the MS-DOS mode and when
using the full screen in [MS-DOS prompt].
When the operation of panning (only LCD) is performed while the screen reso-
lution is set to [1024 x 768 dots], the touchscreen function will not work properly.
If a change is made to the screen resolution, or the cursor can not be pointed
correctly with your finger, be sure to perform [Calibrate]. page 111
(To next page)
Tap and hold the object (i. e. file
or icon), move your finger on the
surface (dragging the object to
the desired location), then re-
lease your finger.
Two quick
taps
One tap