Filter
Top Products
29
1
Connect the external display to your computer
Do not shut down using the suspend or hibernation mode.
Power off your computer ( "Starting Up/Shutting Down")
Turn on the external display, then turn on your computer
3
External Display Port
External Display
You can select either an external display, LCD or simultaneous with Fn
+ F3 .
In addition, you can set the display to use during start-up with the follow-
ing procedure.
For more detailed information, please refer to the operation manual
of the external display.
2
NOTE
1 Run the Setup Utility. ( page 37)
2 Using and , select [Main].
3 Using and , select [Display] and press Enter .
4 Using and , select the display to use and press Enter .
5 Press F10 , then select [Yes].
6 Select your external display.
Set your external display for [Monitor] in [Start] - [Settings] - [Con-
trol Panel] - [Display] - [Settings] - [Advanced Properties].
When a monitor that does not conform to the Plug & Play stan-
dards is connected, select [Change] and make the monitor set-
tings.