Filter
Top Products
13
Function
Suspend function Hibernation function
Where data is saved to
Memory Hard disk
Speed
Fast Somewhat slow
Requires power supply
Yes (if power is cut, all data is lost) Power not required to maintain data
1
Run the Setup Utility ( page 37)
2
Using and , select [Power]
3
Using and , select [Power Switch] and press Enter
Setting the Suspend or Hibernation Function
If you want to immediately start up and continue an application after shutting down
your computer, you can do so by using the suspend or hibernation function.
Starting Up Your Computer Quickly
Suspend/Hibernation Functions
Differences between the suspend and hibernation functions
[Hibernation] is factory set.
CAUTION
Suspend Mode
or
Hibernation Mode
The computer should be set for suspend or hibernation ( see the above proce-
dure).
(After releasing your finger from the
power switch, do not touch the power
switch, keyboard or mouse while the
computer is entering in the suspend or
hibernation modes.)
At the "beep*" sound, release your finger from the power switch. If you con-
tinue to slide the switch and hold it for more than four seconds, the power will
go off. Data not previously saved will be lost.
Slide the power switch to power on.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode be used instead of the suspend mode.
* When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
Setup Utility ( page 38) or by the key combination Fn + F4 , there will be no beep
sound.
Shutting Down Using the Suspend or Hibernation Function
Slide the power switch
4
Press F10 , then select [Yes]
Using and , select [Suspend] or [Hibernation] and
press Enter
5
(To next page)
The Suspend or Hibernation function can be set even with [Panel Switch] in the
Setup Utility. page 41
NOTE