45
8
8. Advanced Operations
Logo print position
To change the setting, proceed as follows.
1
Press (MENU).
2
Press K, then BA.
3
Press (START/SET).
4
Press (‹) or (›) to select the desired
setting.
5
Press (START/SET).
6
Press (MENU).
MODE=OUT [ÿŸ]
LOGO POSITION
SYSTEM SET UP
1
Press (MENU).
2
Press K, then BC.
3
Press (START/SET).
4
Press (‹) or (›) to select “ON”.
¡If this feature is not required, select “OFF”.
5
Press (START/SET).
6
Press (MENU).
¡Then start transmission procedure (see
pages 18 and 19).
MODE=ON [ÿŸ]
MODE=OFF [ÿŸ]
OVERSEAS MODE
SYSTEM SET UP
Logo, telephone number, date, time and page number will be printed on the transmitted document from your
unit in the following manner.
OUT: Outside of the transmitted document’s paper size (pre-selected setting)
IN: Inside of the transmitted document’s paper size
OFF: Not printed
You may experience difficulty in transmitting documents overseas.
This feature will make sending documents easier as the transmission speed is slowed down.
Overseas transmission mode
Note:
¡After the transmission has completed, this feature
will be turned off automatically.
¡When using this feature, transmission time will
increase.
(MENU)
(‹)/(›)
(START/SET)Dial keypad
(MENU)
(‹)/(›)
(START/SET)Dial keypad