Filter
Top Products
8. Programmable Features
37
8.2 Basic features
Feature Feature code Selection
Setting the quick setup {#}{0}{0}{1} “TAM/FAX” (default)
{2} “DIST. RING”
{3} “TEL ONLY”
{4} “FAX ONLY”
See page 15 for details.
Setting the date and
time
{#}{0}{1} Enter the date and time using the dial keypad. See page 16 for
details.
Setting your logo {#}{0}{2} Enter your logo using the dial keypad. See page 17 for details.
Setting your fax
number
{#}{0}{3} Enter your fax number using the dial keypad. See page 18 for
details.
Printing a confirmation
report
{#}{0}{4}{0} “OFF”: Confirmation reports will not be printed.
{1} “ON”: A confirmation report will be printed after every fax
transmission.
{2} “ERROR” (default): A confirmation report will be printed only
when a fax transmission fails.
Changing the ring
count in FAX ONLY
mode
{#}{0}{6}{1} “1”
{2} “2”
{3} “3” (default)
{4} “4”
Note:
L Set feature #77 to “FAX ONLY” (page 41) beforehand.
Changing the ring
count in TAM/FAX mode
{#}{0}{6}{0} “TOLL SAVER”
{2} “2” (default)
{3} “3”
{4} “4”
See page 28 for details.
Note:
L Set feature #77 to “TAM/FAX” (page 41) beforehand.
Changing the maximum
recording time for
incoming messages
{#}{1}{0}{0} “GREETING ONLY”: The unit plays the greeting message but
does not record any incoming messages.
{1} “1 MINUTE”: 1 minute
{2} “2 MINUTES”: 2 minutes
{3} “3 MINUTES” (default): 3 minutes
Setting the remote
operation ID
{#}{1}{1} 1. {MENU} i {#}{1}{1}
2. Enter a 2-digit number (00–99).
L The default ID is “11”.
3. {SET} i {MENU}
Setting the dialing
mode
{#}{1}{3} If you cannot make calls, change this setting according to your
telephone line service.
{1} “PULSE”: For rotary pulse dial service.
{2} “TONE” (default): For tone dial service.
Setting the recording
paper size
{#}{1}{6}{1} “LETTER” (default): Letter size paper.
{2} “A4”: A4 size paper.
Setting the ringer tone {#}{1}{7}{1} “TONE 1” (default)
{2} “TONE 2”
{3} “TONE 3”
FP215-PNQX1896ZA-OI-en.book Page 37 Tuesday, December 23, 2008 11:09 AM