Filter
Top Products
118
Setup from the Front Panel and WebSetup
■ Protocol Setup tab
The options that you can set from the Protocol Setup tab are described
below.
The KX-P8420 can accept jobs via TCP/IP (over either Ethernet or Token
Ring), AppleTalk, and IPX/SPX simultaneously. To configure the KX-P8420,
choose each protocol and enter the settings for that protocol.
Enable Ethernet or, if you have enabled and installed the Token Ring option,
enable Token Ring. If your network uses a gateway, enter the gateway
address.
Enable on Ethernet—Enable this option if you have a TCP/IP network
connected to the KX-P8420 over Ethernet cabling.
You must enable TCP/IP for Ethernet to use the Fiery WebTools over
Ethernet.
IP Address—Enter the KX-P8420 IP address for Ethernet. The KX-P8420
is shipped with the IP address set to the loopback address (127.0.0.1),
which is an internal address used for network checking. If you plan to print
with TCP/IP, you must first assign the KX-P8420 a unique network IP
address. For information about setting up printing with TCP/IP, see “Setting
up TCP/IP printing” on page 53.