Filter
Top Products
132
Color Calibration
To perform Bias Adjustment:
1a
If you wish to adjust the density for all colors
simultaneously, perform the following, then go to step 2.
1)Repeat steps 1 through 3 in “To print a color
calibration page:” on page 129.
Calibration Offset is displayed in the LCD panel.
2)Press the Enter button.
0* (–5 to 5) is displayed in the LCD panel.
3)Press the Continue/Forward or Cancel/Left button
to darken/lighten all the colors.
To make the color density setting of the Color Calibration Page
darker or lighter by 1 level, increase or decrease a value of the
Calibration Offset by 3 by pressing the Continue/Forward or
Cancel/Left button.
For example when Calibration Offset is 0:
•If you wish to make the density setting darker by 1 level:
—Select 3 by pressing the Continue/Forward button 3 times.
•If you wish to make the density setting lighter by 1 level:
—Select –3 by pressing the Cancel/Left button 3 times.
4)Press the Enter button.
CYAN is displayed in the LCD panel.
5)Press the Continue/Forward button 4 times.
Calibration Test Print is displayed in the LCD panel.
1b
If you wish to adjust the density for each color
independently, perform the following, then go to step 2.
1)Repeat steps 1 through 3 in “To print a color
calibration page”.
2)Press the Continue/Forward button.
CYAN is displayed in the LCD panel.
3)Press the Enter button.
0* (–10 to 10) is displayed in the LCD panel.