Filter
Top Products
160
Setup from the Printer Panel and WebSetup
■ Protocol Setup tab
The options that you can set from the Protocol Setup tab are described
below.
The printer can accept jobs via TCP/IP (over either Ethernet or Token Ring),
AppleTalk, and IPX/SPX simultaneously. To configure the printer, choose
each protocol and enter the settings for that protocol.
Enable Ethernet or, if you have enabled and installed the Token Ring option,
enable Token Ring. If your network uses a gateway, enter the gateway
address.
Enable on Ethernet—Enable this option if you have a TCP/IP network
connected to the printer over Ethernet cabling.
You must enable TCP/IP for Ethernet to use the Fiery WebTools over
Ethernet.
IP Address—Enter the KX-PS8100 IP address for Ethernet. The printer is
shipped with the IP address set to the loopback address (127.0.0.1), which
is an internal address used for network checking. If you plan to print with
TCP/IP, you must first assign the printer a unique network IP address. For
information about setting up printing with TCP/IP, see “Connecting the
Printer to a Network” on page 70.