Filter
Top Products
65
Setup
1
Make sure the scanner and printer are turned off.
2
Connect the SCSI cable provided to the scanner’s SCSI
connector A or B and to the printer’s SCSI connector.
3
Make sure the terminator switches (scanner:#4/
printer:#1) are set to ON.
•
To change a terminator setting, see page 66.
4
Connect the power cord to the scanner’s AC inlet and to
an AC outlet.
5
Connect the other power cord to the printer’s AC inlet
and to an AC outlet.
NOTE:
• The Printer function is also available if the printer is connected to the
computer with a parallel interface cable.
DCIS stand alone
system
Scanner’s SCSI
connector
Printer’s SCSI
connector
SCSI cable
1234
ON
1234
ON
OFF
Scanner
Printer