Filter
Top Products
<Checking the display mode for RGB signals>
Use the following procedure to check the display mode for the RGB signals which are currently being input.
Operating procedure
1.
Press
the
MENU
button. The MENU screen will be displayed.
2. Use the “ ” and “
” arrow buttons to move the cursor to “PICTURE”.
3. Press the ENTER button. The PICTURE screen will be displayed.
The display mode for the RGB signals which are currently being input
will appear in the “SIGNAL MODE” item.
4. Use the “ ” and “
” arrow buttons to move the cursor to “PICTURE”.
NOTE:
If the MENU button is pressed, the display will return to the MENU screen,
or the MENU screen will be cleared if it is already being displayed.
<VIDEO/S-VIDEO signal format selection>
If the correct signal format is not selected and the picture does not appear as normal when VIDEO or S-VIDEO
signals are being input, select the format by the following procedure. This function is set to “AUTO” at the time of
shipment from the factory, so that the projector can normally be used with this setting left as it is.
Operating procedure
1. Press the MENU button.
The MENU screen will be displayed.
2. Use the “ ” and “
” arrow buttons to move the cursor to “PICTURE”.
3. Press the ENTER button. The PICTURE screen will be displayed.
4. Use the “ ” and “ ” arrow buttons to move the cursor to “TV
SYSTEM”.
5. Use the “ ”
and “ ”
arrow buttons to switch the setting to “AUTO”,
“NTSC”, “NTSC4.43”, “PAL”, “PAL-M”, “PAL-N” or “SECAM” until a
normal picture is obtained.
Horizontal scanning frequency [kHz]
Vertical scanning frequency [Hz] Color subcarrier frequency [MHz]
AUTO
“AUTO”, “NTSC”, “NTSC4.43”, “PAL”, “PAL-M”, “PAL-N” or “SECAM” is selected automatically.
NTCS
NTSC4.43
15.75
60.00
3.58
PAL
15.63
50.00
4.43
PAL-M
15.75
60.00
PAL-N
15.63
50.00
3.58
SECAM
15.63
50.00
4.25 or 4.41
NOTE:
If using a signal source with poor picture quality, such as a dubbed tape, it may not be possible to get the picture
to display properly.
If the MENU button is pressed, the display will return to the MENU screen, or the MENU screen will be cleared if
it is already being displayed.
NTSC and PAL-M have the same scanning frequencies and color sub-carrier frequencies, but they have
different color modulation methods. Because of this, if the incorrect setting is selected, color pictures may appear
in black-and-white.
22