Filter
Top Products
Using other useful functions
Using the video impose function
This projector can be used to display a VIDEO/S-VIDEO signal image in
a
sub-screen on top of an RGB image
(video impose).
Setting procedure
1. Press the MENU button. The MENU screen will be displayed.
2. Use the “ “ and “ ”
arrow buttons to move the cursor to “VIDEO IMPOSE”.
3. Press the ENTER button.
The VIDEO IMPOSE screen will be displayed.
The position of the sub-screen can be changed by pressing the "
", "
", " " and "
"
arrow buttons.
Press the “ ”
arrow button.
Press the “ ”
arrow button.
Press the “ ”
Press the “ ”
arrow button. arrow button.
Press the “ ”
arrow button.
Press the “ ”
arrow button.
Press the “ ”
arrow button.
Press the “ ”
arrow button.
NOTE:
The video impose function is only effective when RGB signals are being input.
If the FREEZE button is pressed before VIDEO IMPOSE is selected, the video impose function will not operate.
If the MENU button is pressed, the display will return to the MENU screen, or the MENU screen will be cleared if
it is already being displayed.
If the VIDEO button or the RGB button is pressed while the video impose function is operating, the video impose
function will be canceled and the screen will switch back to projecting the input video signal.
If the FREEZE button is pressed while the video impose function is operating, a still picture can be obtained.
However, the input source cannot be switched and the MENU button will not operate until the FREEZE button is
pressed once more to cancel the still picture.
32