Filter
Top Products
Using the power save function
The power save function operates as follows: If the projector continues projecting for 10 minutes or more while there is no
input signal to be projected, the light source lamp will shut off automatically to save power. After 20 minutes, the power
supply will be turned off and the projector will enter standby mode. At the time of shipment from the factory, the power
save function is set to OFF, so that if you would like to use this function, you can turn it on by the following procedure.
Setting procedure
1. Press the MENU button.
The MENU screen will be displayed.
2. Use the “ “ and " ”
arrow buttons to move the cursor to “OPTION”.
3. Press the ENTER button. The OPTION screen will be displayed.
4. Use the " “ and “
” arrow buttons to move the cursor to “POWER SAVE”.
5. Use the “ ” and “ ” arrow buttons to switch the setting to OFF.
NOTE:
If the light source lamp has turned off as a result of the power save function, the power indicator will appear
orange. If a signal is then input, the power source lamp will switch back on and the picture will be projected. If
the power supply has been turned off by this function, it can be turned back on by pressing the POWER button.
If the MENU button is pressed, the display will return to the MENU screen, or the MENU screen will be cleared if
it is already being displayed.
If this function activates while the lens retract function is set to ON, you will need to re-adjust the lens according
to the procedure on page 18.
This function does not operate while the countdown timer is operating.
Using the lens retracting function
This function causes the projector lens to be retracted automatically when the projector switches to standby mode,
and extends the lens again when the projector starts back up again. Having this function set to “ON” is useful if the
projector will not be used for an extended period of time, or when the projector is to be transported somewhere.
However, once the lens has been retracted, it will be necessary to readjust the zoom and focus of the lens once
the projector has been started up again. At the time of shipment from the factory this function is set to “ON”.
Setting procedure
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and “
” buttons to select “OPTION”.
3. Press the ENTER button to display the OPTION screen.
4. Press the “ ” and "
” buttons to select “LENS RETRACT”.
5. Press the “ ” and “
” buttons to change the setting to “ON”.
If you set this function to “ON”, the lens will be extended and retracted
each time the power is turned on and off.
NOTE:
If this function is set to “OFF”, the lens will remain extended at all times.
If the MENU button is pressed, the display will return to the MENU screen, or
the MENU screen will be cleared if it is already being displayed.
36