Filter
Top Products
<Back, bottom and right view>
Lamp unit cover
(page 47)
Remove this cover to get access
to the lamp unit.
Fixing screw for the lamp
unit cover
(page 47)
Remove this screw when
replacing the lamp unit.
Front
Adjuster button
(page 17)
This button is used to
unlock the adjustable legs.
Adjustable legs (two)
(page 17)
These legs can be used to adjust
the angle of inclination of the
projector.
Remote control signal receptor
(page 10)
This receives the infrared signal transmissions from the
remote control unit.
Fixed legs
Air filter
<Side terminal board>
AUDIO OUT terminal
(pages 38 and 39)
This terminal is used to output the audio signals from
the source which is connected to the AUDIO IN
terminals for RGB or video signals.
The signal which is output corresponds to the source
which has been selected by pressing either the
VIDEO or RGB button. The output level for this signal
can be adjusted by using the VOL +/-buttons.
If audio equipment is connected to this terminal, no
sound will be output from the built-in speakers.
RGB OUT connector
(page 39)
This connector is used to output the RGB
signals from the source which is connected
to the RGB 1 or RGB 2 connector.
The signal which is output
corresponds to the source
which has been selected by
pressing the RGB button.
RGB 2 (RGB IN/AUDIO IN)
connector/terminal
(page 39)
This connector and terminal
are used to input RGB signals
and the audio signal which
accompany them.
RGB 1 (RGB IN/AUDIO IN)
connector /terminal
(page 39)
This connector and terminal are used to
input RGB signals and the audio signal
which accompany them.
S-VIDEO IN terminal
(page 38)
This terminal is used to input S-VIDEO signals.
VIDEO IN terminal
(page 38)
This terminal is used to input composite
video signals.
AUDIO IN (L-R) terminals for S-
VIDEO/VIDEO input
(page 38)
These terminals are used to input
audio signals which correspond to
the signals input to the VIDEO IN or
S-VIDEO IN terminal.
SERIAL connector
(page 41)
This connector is used to con-
nect a personal computer to
the projector in order to exter-
nally control the projector.
MOUSE connector
(pages 39 and 40)
This connector is used to connect an accessory or
separate mouse cable. This lets you operate a
personal computer using the pointer button and click
buttons on the remote control unit instead of using --
mouse.
8