Filter
Top Products
Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 77
[COOLING CONDITION]
Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] correctly in accordance with the direction of projection referencing the following gure. Using the light source with
incorrect settings may shorten its life.
15°
15°
15°
15°
30°
30°
30°
30°
[VERTICAL UP SETTING]
[FLOOR
SETTING]
[CEILING
SETTING]
[VERTICAL DOWN SETTING]
[PORTRAIT SETTING]
Projection direction
Frontward: Projection direction
[FLOOR SETTING]
[CEILING SETTING]
1) Press as to select [COOLING CONDITION].
2) Press the <ENTER> button.
f The [COOLING CONDITION] screen is displayed.
3) Press as to select a cooling condition.
4) Press the <ENTER> button.
5) When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[HIGH ALTITUDE MODE]
Set to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea level.
1) Press as to select [HIGH ALTITUDE MODE].
2) Press qw to switch the item.
[OFF] When using at a location lower than 1 400 m (4 593') above sea level
[ON] When using at high altitudes (between 1 400 m (4 593') and 2 700 m (8 858') above sea level)
3) When the confirmation screen is displayed, press qw to select [OK] or [CANCEL], and press the
<ENTER> button.
Note
f The speed of the fan increases and the operation sound becomes louder when set to [ON].
[ECO MANAGEMENT]
A function that optimizes the light source power to suit usage conditions to reduce power consumption.
Setting [LIGHT POWER]
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [LIGHT POWER].
4) Press qw to switch [LIGHT POWER].
f The items will switch each time you press the button.
[NORMAL] Sets when high luminance is required.
[ECO SAVE1]
Reduces the power by approximately 20 % in average compared to [NORMAL] without affecting the
brightness.