Panasonic PT-RZ470UK Projector User Manual


 
Chapter 1Preparation — Start-up display
20 - ENGLISH
Start-up display
The initial setting screen is displayed when the projector is switched on for the rst time after purchase as well as when [ALL USER DATA] in
the [PROJECTOR SETUP] menu [INITIALIZE] is executed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
Note
f When the projector is used for the rst time, you may be required to adjust the lens zoom ring and focus ring of the projector (x page 22)
to display the menu screen clearly.
Refer to “Adjusting the image” (x page 37) for details.
Initial setting (display language)
Select the language to show on the screen.
1) Press as to select the display language.
ENTER
INITIAL SETTING
SELECT
SET
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (projector setup)
Set each item.
1) Press as to select an item.
2) Press qw to switch the setting.
ENTER
INITIAL SETTING
SELECT CHANGE
SET
PROJECTION METHOD
COOLING CONDITION
SCREEN FORMAT
SCREEN POSITION
16:10
HIGH ALTITUDE MODE
SWITCH TO HIGH ALTITUDE MODE "ON" IF
OVER 1400m(4593Ft).
OFF
FRONT/FLOOR
FLOOR SETTING
f [PROJECTION METHOD] and [COOLING CONDITION] (x page 26)
f [SCREEN FORMAT] (only for the PT-RW430U series)
Select [16:10] or [16:9] based on the screen in use.
f [SCREEN POSITION] (only for the PT-RW430U series)
The vertical position can be adjusted between
-
40 and 40 only when [SCREEN FORMAT] is set to [16:9].
f [HIGH ALTITUDE MODE]
Set to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea level.
3) Press the <ENTER> button.
f Fix the setting value to complete the initial setting.
Note
f If you press the <RETURN> button on the initial setting (projector setup) screen, you can go back to the initial setting (display language)
screen.
f [SCREEN FORMAT] and [SCREEN POSITION] are available only for the PT-RW430U series.
f To continue operations after completed the initial settings (projector setup), refer to “Selecting the input signal” (x page 37).
f By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR
SETUP] menu [DATE AND TIME] [TIME ZONE] to the time zone of the region where you use the projector.