Filter
Top Products
Chapter 4 Settings — [PROJECTOR SETUP] menu
82 - ENGLISH
[BRIGHTNESS CONTROL STATUS] screen display example
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[OFF]
The screen shows the status that the brightness control is disabled.
MENU
1
RETURN
BRIGHTNESS CONTROL STATUS
MODE
PROJECTOR
OFF
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[AUTO] and [LINK] is set to [OFF]
The screen shows the status of the brightness control in one
projector
MENU
5
1
6
RETURN
LINK
PROJECTOR
OFF
BRIGHTNESS CONTROL STATUS
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[AUTO] and [LINK] is set from [GROUP A] to [GROUP D]
The screen shows the status of the brightness control of
synchronized projectors (up to eight units), including the projector
being controlled through the on-screen menu.
2
1
3
4
5
7
8
1:
2:
3:
4:
5:
6:
7:
192. 168. 30. 2
192. 168. 30. 3
192. 168. 30. 4
LINK
UPDATE
PROJECTOR
GROUP A
PROJECTOR2
PROJECTOR3
BRIGHTNESS CONTROL STATUS
MENU SELECT
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[PC]
MENU
5
1
6
RETURN
MODE
PROJECTOR
PC
BRIGHTNESS CONTROL STATUS
1 Display the name of the projector.
2 Display the synchronized group.
3 Display the IP address of the projector.
4 Display the names and IP addresses of projectors in same
group detected over the network.
5 Display the status by color.
Green: There is an allowance for brightness correction.
Yellow: There is little allowance for brightness correction.
Red: There is a brightness control error.
6 Display error detailed messages.
7 Display error messages.
When the message [Failed to apply BRIGHTNESS CONTROL
to some projectors.] appears, it means that synchronization with
the projector displayed in red has failed.
Press as to select the projector displayed in red, and press
the <ENTER> button to display the error details.
8 Update to the latest status information.
r Error details
Error message Measures to take
[Exceed maximum number of
projectors.]
f Limit the number of projectors in one group to eight.
f When synchronizing nine or more projectors, use the dedicated software “Multi Projector
Monitoring & Control Software”
*1
through a computer.
[Please check the COMMAND
CONTROL setting.]
f Set [COMMAND CONTROL] in [NETWORK CONTROL] of the projector displaying an error to
[ON].
f Assign the same value to [COMMAND PORT] of the [NETWORK CONTROL] of all projectors to be
synchronized.
[Please check the USER NAME
and PASSWORD in the COMMAND
CONTROL setting.]
f Assign the same [User name] and [Password] strings of the web control administrator rights of all
projectors to be synchronized.
[Cannot apply BRIGHTNESS
CONTROL. Please check projector
status.]
f The projector is in standby. Switch on the power.