Filter
Top Products
Using Remote control
24
- ENGLISH
Preparation
Using Remote control
Installing and Removing batteries
Open the cover1 ) Install batteries and close the cover2 )
(Insert the – side rst.)
Remove the batteries in the reverse order of
z
installation.
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are 7 different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].
J
Setting the ID number
1) While holding down the <MENU> button, press the Number Buttons, the number
you press the Number buttons corresponds to the desired ID code number.
2) The number you press the number buttons are as follows: Code 1= <1 MUTE>,
Code 2= <2 D.ZOOM +>, Code 3= <3 VIDEO>,
Code 4= <4 FREEZE>, Code 5= <5 D.ZOOM ->, Code 6= <6 S-VIDEO>.
3) The ID code is reset to [ALL] (default) by pressing the <MENU> button and
<0 LAMP> button at the same time for 5 seconds or more.
Attention
The status of the ID code is not stored after replacing batteries.
z
Note
For details, please refer to the [Remote control] of the [Setting] menu.
z
(
Æ
page 61)
MENU button
Number buttons