Filter
Top Products
Index
Index-53980-A2-GB30-40 October 1998
S14 (Asymmetric Rate Mode), 13-20
S15 (Asymmetric Rate Mode), 13-20
S18 (Test Timeout), 8-41, 13-20
S23 (Proactive Retrain), 13-20
S26 (RTS/CTS Delay), 8-12, 13-20
S28 (SDC Negotiation), 13-21
S29 (SDC Idle Fill), 13-21
S31 (SDC Bit Encoding), 13-21
S32 (Sync DTE CRC), 13-22
S35 (Auto Redial), 13-22
S36 (Rate Auto Originate), 8-30, 13-22
S37 (Auto Redial), 8-23, 8-31
S37 (DTR Auto Redial), 13-23
S38 (DTR Continuous Repeat), 8-18, 13-23
S39 (Receive Buffer Disconnect Delay), 8-39, 13-23
S40 (Auto Make Busy), 8-22, 13-23
S41 (Dial Line Rate), 13-24
S43 (Train Time), 8-26, 13-24
S44 (Leased Line Rate), 8-24, 8-29, 13-25
S45 (Leased Line Transmit Level), 8-30, 13-25
S46 (Bad Lines Auto Originate), 8-30, 13-25
S47 (Auto Dial Standby), 8-31, 13-26
S48 (Leased–Line Carrier On Level), 8-31, 13-26
S49 (Transmit Buffer Disconnect Delay), 8-39, 13-26
S51 (DTE Remote Loopback), 8-41, 13-26
S52 (DTE Local Loopback), 8-41, 13-26
S53 (V.54 Address), 8-42, 13-27
S54 (V.54 Device Type), 13-27
S55 (Access from Remote), 8-44, 13-27
S56–S59 (Remote Access Password), 8-44, 13-27
S61 (CT111 Rate Control), 8-13, 13-27
S62 (V.25bis Coding), 8-17, 13-28
S63 (V.25bis Idle Character), 8-17, 13-28
S64 (V.25bis New Line Character), 8-17, 13-28
S66 (NMS Call Messages), 8-45, 13-28
S67 (Directory Location 1 Callback), 8-44, 13-28
S69 (Make Busy Via DTR), 8-22, 13-28
S74 (Network Position Identifier), 8-45, 13-29
S75 (Network Management Address), 8-44, 13-29
S76 (Autorate), 8-25, 13-29
S77 (DTR Alarm Reporting), 8-45, 13-29
S78 (Automode), 8-25, 13-29
S80 (No Data Disconnect Trigger Signal), 8-22,
13-30
S82 (Autorate), 8-29, 13-30
S83 (MI/MIC Dialing), 8-23, 13-30
S84 (AT Command Mode), 8-18, 13-30
S85 (Fast Disconnect), 8-20, 13-30
S88 (Straps When Disconnected), 8-43, 13-31
S89 (V.42 ARQ Window Size Increase), 13-31
S90 (DTE Rate = VF Rate), 8-13, 13-31
S91 (Cellular Enhancements), 8-40, 13-31
S92 (V.29 Train On Data), 13-32
S93 (Cellular RJ11 Adapt), 8-45, 13-32
SDCP (Shared Diagnostic Control Panel), 3-1
SDLC, 8-34
SDU (Shared Diagnostic Unit), 3-1
secondary channel, 10-2
Security branch, 11-4
Security configuration options, 8-46
security messages, 4-7
Self (Test branch), 7-2
self-test, 7-2
Send Break Control, 8-39
serial number, 13-5
Service Line, 9-3
Set Access Control, 11-4
Set Administrative Password, 11-10
Set Answer Security, 11-8
Set Originate Security, 11-9
setting factory defaults, 4-11
Speaker Control, 8-43, 9-2
Speaker Volume, 8-44
status, 4-7
Status branch, 6-1
status indicators, 4-2
Stop Bits, 8-9
store telephone number (&Z), 13-12
Straps When Disconnected, 8-43
Sync DTE Rate, 8-8
synchronous data compression, 1-2, 8-34, I-1
Synchronous Data Compression (SDC)
SDC Bit Encoding (S31), 13-21
SDC Idle Fill (S29), 13-21
SDC Negotiation (S28), 13-21
Sync DTE CRC (S32), 13-22
Sync DTE Rate (S30), 13-21
T
technical specifications, D-1
telephone interface, D-3
telephone numbers, entering, 5-5
Test branch, 7-2
Test Timeout, 8-41
tests (&T), 13-12
top-level menu, 4-7
Train Time, 8-26
Transmit Buffer Disconnect Delay, 8-39
Transmit Clock Source, 8-13
transmit level, D-3
dial, 13-10
leased line, 13-25
troubleshooting, C-1
U
UNIX, G-1, G-2
upgrade instructions, 9-6
V
V.22bis Guard Tone, 8-26
V.25bis Coding, 8-17, 13-28
V.25bis commands, F-3
V.25bis dialing commands and responses, F-1
V.25bis Idle Character, 13-28
V.25bis Idle Fill, 8-17
V.25bis New Line Character, 8-17, 13-28