Filter
Top Products
Setting Up
5-33
9161-A2-GH30-30
April 1998
Table 5-7. OCU-DP Options – Slot ss Port p Options (2 of 3)
Port Rate
Possible Settings: 56K, 64KCC, Switched_56
Default Setting: 56K
Selects the rate for the port.
H Port Rate only appears if Port Status is set to Enable.
56K – The setting for 56 kbps.
64KCC – The setting for 64 kbps Clear Channel.
Switched_56 – The rate for 4-wire Switched 56.
Loopback Detection
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether the the T1 access unit will detect loopback activation codes coming
from the network.
H Loopback Detection only appears if Port Status is set to Enable.
Enable – Loopback code detection is enabled.
Disable – Loopback code detection is disabled.
Loss of Signal Alarm
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether an ASCII alarm will be generated when a Loss of Signal condition
is detected.
H Loss of Signal Alarm only appears if Port Status is set to Enable.
Enable – An alarm is generated when a Loss of Signal condition is detected on the
interface.
Disable – Alarms are not generated for a Loss of Signal condition.
Abnormal Station Code Alarm
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether an ASCII alarm will be generated when an Abnormal Station code
is received from the network.
H Abnormal Station Code Alarm only appears if Port Status is set to Enable.
Enable – An alarm is generated when an Abnormal Station Code is received from the
network.
Disable – Alarms are not generated when an Abnormal Station Code is received.