Filter
Top Products
Setup Command Menu 78
Model 2160 Series User Manual 5 • Console and Telnet configuration
Line Probe
For adaptive mode applications, set the Line Probe to Enable. The Model 2160 will adapt the data rate accord-
ing to the line status. For all other applications, set the Line Probe to Disable.
Clear
Use the clear command to reset the CRC error count.
LAN
The lan command menu lists commands for setting up the LAN ports. Move the cursor “ >>” to lan in the
setup menu and press Enter.
-----------------------------------------------------------------------------
Command: setup lan <1~1>
Message: Please input the following information.
Interface number <1~1>: 1
-----------------------------------------------------------------------------
The default interface number is 1.
You can configure the Link type, LAN IP address and subnet mask for the LAN interface.
Table 18 shows the options available within the lan command menu:
-----------------------------------------------------------------------------
Command: setup lan 1 link_type <Disable|Dynamic|Static>
Message: Please input the following information.
Link type (TAB Select) <Disable>:
-----------------------------------------------------------------------------
Select the lan 1 link_type as Disable, Dynamic or Static. Then, select address from the lan menu:
-----------------------------------------------------------------------------
Command: setup lan 1 address <ip> <netmask>
Message: Please input the following information.
IP address (ENTER for default) <192.168.2.1>:
Subnet mask (ENTER for default) <255.255.255.0>:
-----------------------------------------------------------------------------
Set the LAN IP address and subnet mask. The default IP Address is 192.168.2.1 and the default subnet mask
is 255.255.255.0.
>>
link_type Configure Link type
address LAN address and subnet mask
Table 18. LAN Options
Menu Options
Link Type Disable Dynamic Static
IP Address
Subnet Mask