Peerless Industries HDS200 Network Router User Manual


 
17 of 36
ISSUED: 07-24-12 SHEET #: 180-9023-1
3. VIDEO OUT (Receiver) - Selects the Audio/Video output port of the Receiver.
• HDMI - Selects HDMI as the Audio/Video output.
• Component - Selects Component as the Audio/Video output.
• AV - Selects AV as the Audio/Video output.
Note: Remote must be pointing at the Receiver directly to control its output settings. This may also be
accomplished without the use of the remote control by toggling between outputs via the Power/Source Selection
Button.
4. VIDEO IN (Transmitter) - Selects the Video input port of the Transmitter.
• HDMI1 - Selects HDMI1 as the Audio/Video input.
• HDMI2 - Selects HDMI2 as the Audio/Video input.
• PC - Selects VGA/Component as the Video input.
• AV - Selects Composite as the Video input.
5. AUDIO IN (Transmitter) - Selects the Audio input port of the Transmitter.
• HDMI1 - Selects HDMI1 as the audio input.
• HDMI2 - Selects HDMI2 as the audio input.
• PC - Selects PC audio-in as audio input.
• AV - Selects Composite audio-in as the audio input.
Notes:
1. By default, when a video input is selected the audio will automatically be switched to the same input
where audio is available.
2. Independent audio switching is only allowed for AV Audio and PC Audio.
6. LAN* (Red) - Selects LAN (wired) mode.
7. WiFi CH1** (Green) - Selects WiFi (Wireless) mode, Ch1.
8. WiFi CH2** (Yellow) - Selects WiFi (Wireless) mode, Ch2.
* Press and hold the LAN button for approximately 6 seconds to change the connection setting to Wired Mode.
** To change WiFi channels press and hold the desired WiFi channel button for approximately 6 seconds or until
the Link Indicator Light starts blinking.
Note: If the WiFi channel is changed while the wireless connection between the Transmitter and Receiver is
active, noted by a solid Link Indicator Light, the WiFi frequency of the Transmitter and the Receiver will be
changed simultaneously. If the WiFi channel is changed while the connection between the Transmitter and the
Receiver is not established, noted by a ashing Link Indicator Light, ONLY the unit that receives the IR signal
will change WiFi frequencies. For proper operation both Transmitter and Receiver need to be on the same WiFi
channel.