Peerless Industries HDS200 Network Router User Manual


 
21 of 36
ISSUED: 07-24-12 SHEET #: 180-9023-1
Step 5
Powering-up the HD Flow Multimedia Kit
Plug in the power adapters for the Transmitter and the Receiver to available power outlets. Plug in the other
end of the power cable to the Transmitter and then to the Receiver. The units will automatically turn on.
Step 6
Turn on your display device (TV, monitor, projector, etc.)
Step 3
Connecting the Receiver to the Display Device
Note: Connect the Receiver to the display device
using the port with the high resolution capability,
HDMI port is preferred. Regardless of the
number of analog or digital sources connected
to the Transmitter, only one port is required to
be connected to the display. Be sure the source
resolution matches with the display device's
resolution capabilities.
A. HDMI Output to Display
Connect the HDMI cable from the
Receiver's HDMI output to the display
device's HDMI input.
B. Composite Output to Display
Connect the composite RCA cable from the Receiver's AV output to the display device's composite
input.
C. Component Output to Display
Video - Connect the component video (YPbPr) cable from the Receiver's COMPONENT-OUT to the
displays device's component input.
Audio - A 3.5mm-to-RCA stereo audio cable is required (not included) to transmit audio when using this
input. Connect the 3.5mm end of the cable to the Receiver's AUDIO-OUT port, then connect the RCA
side of the cable to the RCA ports on the display decive.
Step 4
Install the IR Extender by plugging in the provided IR Extender into the IR-IN port on the Receiver. (IR Extender
use is optional. Use the IR Extender when the Receiver is out of sight or to extend the range of the Receiver's
IR reception range.)