Peerless Industries HDS200 Network Router User Manual


 
30 of 36
ISSUED: 07-24-12 SHEET #: 180-9023-1
Factory Reset
CAUTION
Factory reset will revert all settings to factory defaults. It is not recommended to perform factory reset
on multicast systems (systems that have two or more Receivers). If there are issues with multicast
systems, please reference http://www.hd ow.com/Tech-Support or call Technical Support at
1-800-865-2112.
Step 1
Unplug the unit from its power source.
Step 2
Press and hold the Power/Source Selection Button on the front panel. Plug in the DC power back into the unit
being reset.
Step 3
Keep holding the Power/Source Selection Button until the Indicator Lights on the unit are ashing rapidly,
approximately 3 seconds.
Step 4
Release the Power/Source Selection Button and wait for the unit to reset to factory defaults.
Please visit http://www.hd ow.com/Tech-Support to view factory reset training video.
Firmware Upgrade
Visit http://www.hd ow.com/Tech-Support/index.html for Peer-to-Peer and Multicast rmware upgrade
instructional videos, le downloads and unit con gurations.
Notes:
1. HD Flow Pro Wireless Multimedia Kit, Peer-to-Peer units and Multicast units have been pre-con gured
with the same version of rmware. When purchasing additional Receiver(s) it is recommended to check
the rmware version.
2. Firmware update should only be done when units are functioning properly.
3. During the update, DO NOT TURN THE UNIT OFF OR UNPLUG ITS POWER SOURCE. Doing so will
cause the unit to no longer function properly.
4. During the update process the display device will not show content.
5. Only when the unit(s) have nished updating and rebooted should the USB dongle be removed.
Appendix