Pelco DX8100-ISCI Computer Hardware User Manual


 
Tech
Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 1 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm
INSTALLING THE DX8100-ISCI SCSI CARD
WITH SATABOY
April 16, 2008
TOOLS NEEDED
GETTING READY
Before you install the DX8100-ISCI SCSI card, familiarize yourself with the instructions in this Tech
Tip. The steps to install the external video storage upgrade are summarized as follows:
1. Unpack the DX8100-ISCI kit and check that you have all the necessary kit components.
2. Verify that you have the required tools to install the SCSI card. For information about the tools
required to install the SCSI card, refer to Tools Needed table above.
3. Shut down the DX8100 Series DVR. For information about shutting down the DX8100, refer to the
DX8100 Installation Manual, Operation and Programming manual, or DX8100 Server online Help.
4. Unplug the power cord from the wall socket.
WARNING: It is critical that the unit be unplugged for your safety. You must remove the power
cord because current continues to flow through the DX8100 even when the unit is off. Remove
the power cord from the wall socket first, and then from the rear of the DVR.
Qty Description
1 Phillips screwdriver #1 (nonmagnetic)
1
Properly grounded electrostatic discharge (ESD) wrist
strap and mat
4 Small containers for storing screws (optional)