Filter
Top Products
Tech
Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 2 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm
Figure 2. Removing Power Cord from Wall
1. Remove the power cord from the back of the DX8100.
2. Ensure that the DX8100 Series DVR and all of its components are protected against ESD. Before
handling any electronic components, you should take steps to ground yourself properly so that any
built-up static electric charges are dissipated away from the unit. The most effective method for
combating ESD is to use a properly grounded wrist strap. Refer to Figure 4.
Figure 3. Removing Power Cord from DX8100
NOTE: If you do not have access to a grounded wrist strap, you can discharge any built-up static by
periodically touching an unpainted section of the chassis.
Figure 4. ESD Protection