Filter
Top Products
Tech
Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 5 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm
MOVING THE MAIN CAPTURE CARD TO SLOT 3
In the DX8108 and DX8116 base DVRs, the main Capture Card is installed in slot 2. To install the
DX8100-ISCI SCSI card, the main Capture Card must be removed from slot 2 and re-installed into slot
3. This step is necessary because the DX8100-ISCI SCSI card must be physically installed in slot 2.
Move the main Capture Card from slot 2 to slot 3:
1. To ready the main Capture Card for removal:
a. Remove the rear cross-brace.
b. Remove the slot cover for slot 3 and retain the screw.
c. Remove the bracket screw that secures the main Capture Card in slot 2.
d. Disconnect the 32-pin ribbon cable.
e. Disconnect the 5-wire TV/Audio cable and lay the cable over the DX8100 I/O Card.
f. Disconnect the 7-wire TV/Audio cable.
g. Disconnect the 2-wire audio cable.
Figure 7. Readying Main Capture Card for Removal
2. To move the main Capture Card:
a. Remove the capture Card from slot 2 and firmly seat the Capture Card in the PCI connector for
slot 3.
b. Secure the Capture Card bracket with the screw.
c. Reconnect the 5-wire TV/Audio cable.