Filter
Top Products
Tech
Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 15 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm
e. Click Back.
f. Make sure to delete each raid array.
6. Add Raid Array. (See Figure 10)
a. Select Add Array tab.
b. Type name next to array name. Raid1 is a sample name.
c. Select all disks except Pool Spare.
d. Click Create Raid Set button.
e. Click Back.
Figure 10
7. Add Volumes Note: The first volume is automatically set up after the Raid array is created. More
Volumes need to be created based on the HDs of SATABoy (three volumes for 14 HDs SATABoy
and two volumes for 8HDs SATABoy). The volume size limit is 1.7 TB.
a. Select the CONFIGURE VOLUMES option under the main menu.
b. Select ADD VOLUME.
c. Change the unit by placing a dot next to % and click Change Units.
d. Click Back.
e. Type the name next to Enter the name for the new volume. Volume #2 is a sample name
f. Type 100 next to Enter the size of the new volume in % of array capacity.
g. Place a check mark next to Limit volume size to less than 2TB.
h. Select LUN0 next to Select LUN for new Volume on port 0. (Select LUN1 for Volume 2 and so
on)