Filter
Top Products
Tech
Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 6 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm
d. Reconnect the 7-wire TV/Audio cable.
e. Reconnect the 2-wire audio cable.
Figure 8. Moving Main Capture Card
INSTALLING THE DX8100 SCSI CARD
The DX8100-ISCI SCSI card is shipped separately. The SCSI card is installed in the PCI slot 2 on the
motherboard.
To Install the DX8100-ISCI SCSI card:
1. Verify that the main Capture Card is installed in slot 3. For information about moving the main
Capture Card from slot 2 to slot 3, refer to Moving the Main Capture Card to Slot 3 on page 5.
2. To install the SCSI card into slot 2:
a. Firmly seat the DX8100-ISCI SCSI card in the PCI connector for slot 2.
b. Secure the DX8100-ISCI SCSI card bracket with the screw removed from slot 3.
c. Reconnect the 32-pin ribbon cable to the first 32-pin connector (on the main Capture Card) in
slot 3.
3. Replace the rear cross-brace.
Note: Connect the 68-pin high density cable to the bottom port of the SCSI card. Connect the other
side to Host 0 on the bottom port of the SATABoy.