Filter
Top Products
Tech
Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 9 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm
Figure 2
1. Connect to a PC and SATABoy with Cat5 Crossover cable.
2. Turn on the SATABoy and wait until three LEDs come on. (See Figure 3)
3. Turn on the PC.
For New SATABoy with 8 or 14 HDs: Configure Computer
1. Right click on My Network Place on the desktop and then left click Properties.
2. Right click Local Area Connection and then left click Properties.
3. Left click Internet Protocol (TCP/IP).
4. Click Properties.
5. Select Use the following IP address. (See Figure 4)
a. Record the current IP and Subnet addresses on the travel tag for later to use.
b. Change the IP address to 10.11.12.13.
c. Change the Subnet mask to 255.255.255.0.
d. Click OK.
e. Click Close.