Filter
Top Products
27964-01A
12
Installation - Electrical Connections
Electrical Connections
At the rear of the bed, insert canopy plug
(A) into bench socket (B). Connect power
cord (C) as described in Pre-Installation
Planning. Again, a professional electrician
is recommended. The Remote Control
Bypass plug is already installed in one of
the remote control ports as shown. Your
sunbed will not operate without the
Remote Control Bypass plug or a remote
system connected. Remove the protective
film from the acrylic shields. Your equip-
ment is now ready for use.
NOTE: Your sunbed is designed to accept
an input from a remote control device.
The remote control is optional. If you
plan on using a remote system refer to
Remote Connections.
ATTENTION: Although the Remote
Control Bypass plug provided with your
sunbed will work wherever a T-Max® ter-
minator is called for in the series, the T-
Max® terminator will not work as a
bypass plug. A bypass plug is needed only
when your sunbed is operated without a
remote system connected.
Remote Control
Bypass plug
Remote Control
Ports