Filter
Top Products
27964-01A
21
Care and Maintenance - Lamp and Acrylic Replacement
Lamp and Acrylic Replacement
Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approximate-
ly 800-1000 hours of use. Tanning will
continue after this time but at a slower
rate. To ensure trouble-free operation of
your sunbed, replace the lamp starters
whenever the lamps are replaced.
Removing/Replacing Acrylic Shield
The acrylic shield in the bench and
canopy are secured in place by hinged
profiles which run the length of the bed,
both front and back. Simply pry up on the
inside edge of the profile, starting at the
center of the bed
, until it releases its latch-
ing action (see figure at right). Continue to
pry up the profile across its entire length
until it swings back freely. Repeat for the
other profile. The long edges of the acrylic
shields are now exposed.
Standing at the front of the unit, lift the
exposed edge of the acrylic slightly and
carefully begin sliding it toward you until
it is removed from the sunbed. This might
be easier with the help of another person.
After changing the lamps, replace the
acrylic shield by carefully aligning it with
the channels on the ends of the sunbed
and sliding it into place. Close the hinged
profile by pushing it back into place until
it snaps tight.
CAUTION
Be careful. The edges of the acrylic shield
may be sharp.
WARNING
Shock hazard.
Disconnect power before servicing.