Filter
Top Products
27964-01A
22
Care and Maintenance - Lamp and Acrylic Replacement
Removing/Replacing Lamps
After removing the acrylic shield, replace
lamps as follows.
Step 1 Grasp the lamp at one end and
at the middle and turn the lamp
one quarter turn. Gently remove
the lamp from its holders.
Step 2 Reinstall the lamp by inserting
the pins located on the ends of
the lamp into the slots on top of
the lamp holders and turn the
lamp a quarter turn. It should
click in place.
Recommended Replacement Lamps
We recommend using the lamps specified
below. Use of uncertified lamps is a viola-
tion of Federal regulations and will void
your warranty. These lamps have an aver-
age life of 800-1000 hours of effective
tanning use. Lamps used longer than that
begin to lose their effectiveness even
though they continue to light.
Recommended Replacement Acrylics
Acrylics vary greatly over time in their
ability to effectively transmit UV light.
Acrylics sold by ETS have been life tested
to ensure proper transmission throughout
their useful life.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT:
Velocity® Wolff® Model VEL 71-T12-100W
Heraeus E400 HPT, Philips Model HPA 400/30s or CosmoTech Model 23045
(SolarMax™ IFT facial unit in 30 3F and 32 3F)