Filter
Top Products
27964-01A
15
Installation - Remote Connections
After you have set the T-Max® 1A’s, or 3A’s, address
to “0” (refer to your T-Max® user’s guide) and the
sunbed’s address to “1”, simply connect the RJ-22
modular cables, described in the T-Max® user’s
guide, directly into either of
the smaller ports located on
the back of the canopy and
either port on the back of
the T-Max® 1A or 3A.
Scenario 4 - T-Max® Manager Series with
Wireless combo 2
Wireless can be easily added to an existing
salon already utilizing T-Max®. Connect one
AP-900 (with Power Injector) to the Manager
and one AP-900 to each wireless ready tan-
ning bed. The rest of the salon may be
“daisy-chained” together and connected to
the Manager.
Scenario 5 - T-Max® Manager Series
with wires
As always, this tanning bed is fully com-
patible with a wired T-Max® system.
Simply connect the RJ-22 modular cable(s),
described in the T-Max® Manager manual, into
either of the smaller remote port(s) located on the
back of the canopy and follow the instructions
that came with your remote system.
Scenario 6 - Single Bed wired to T-Max® 3A
In single sunbed installations, the T-Max® 1A and
3A can offer the same control as the T-Max®
Manager, eliminating the need for a Manager. If
you’re using a 1A in this manner, it must
have a
chip labelled “master” installed on its circuit
board. The remote control bypass plug must not
be
used in this configuration. The 3A may be used as
a “master” with no modification.