Filter
Top Products
27964-01A
18
Operation - Using Your Sunbed
1. Lift the canopy, lie down on the bench
(face up), lower the canopy toward your
body using the canopy handle. See Safety
Information for positioning instructions.
2. Put on your safety goggles.
3. Assuming the remote system has been set
to allow a pre-tanning delay time, the timer
display (E) will repeatedly flash the delay
symbol “dL” and then the remaining delay
time. Press the timer button (G) or wait
until the delay time has expired to begin
the tanning session. The lamps will turn on
and the timer will begin to count down.
4. When the timer reaches 0 the lamps turn
off. If you want to stop your session before
time expires, press the stop button (F).
5. Raise the canopy by using the outer edge,
do not push up on the acrylic shield
. The
cooling fans run for a period of time after
the lamps shut off to aid in cooling the
sunbed. The timer will indicate “..” as a
reminder to clean the sunbed. After the
sunbed is cleaned press the timer button
and the display will return to “0”.
Using Your Sunbed
When connected to the T-Max® Manager or T-Max® 1A or 3A.
A Face tanner control - Turns face tanners
on and off during use. Face tanner
lamps require one minute to relight.
(Units equipped with face tanner only)
B Body tanner control - Turns body lamps
on and off during use. (Units equipped
with face tanner only)
C Body fan control - Controls the speed of
the body fan during use.
D Body fan speed indicator - Indicates
speed of fan. (OFF - LOW - MED - HI)
E Timer display - Displays remaining time.
F Stop button - Interrupts tanning session.
G Timer button - Turns bed on. Timer dis-
play shows remaining time.
AB CDEF G
WARNING
Wear protective eyewear.
Failure to may result in severe burns or
longterm injury to the eyes.