Filter
Top Products
27964-01A
1
Operation - Using Your Sunbed
19
Using Your Sunbed
When used as a stand alone unit or when connected to a remote system using a control relay.
1. Lift the canopy, lie down on the bench
(face up), lower the canopy toward your
body using the canopy handle. See Safety
Information for positioning instructions.
2. Put on your safety goggles.
3. Press the timer button (G) to begin the tan-
ning session. The lamps will turn on and
the timer will begin to count down.
4. If a tanning time less than the displayed
time is desired repeatedly press the timer
button (G) to decrease the remaining time.
5. When the timer reaches 0 the lamps turn
off. If you want to stop your session before
time expires, press the stop button (F). You
will have ten seconds to restart with the
remaining time, otherwise the timer will
reset to 0.
6. Raise the canopy by using the outer edge
of the canopy, do not push up on the
acrylic shield
. The cooling fans run for a
period of time after the lamps shut off to
aid in cooling the sunbed.
AB CDEF G
A Face tanner control
- Turns face tanners
on and off during use. Face tanner
lamps require one minute to relight.
(Units equipped with face tanner only)
B Body tanner control - Turns body lamps
on and off during use. (Units equipped
with face tanner only)
C Body fan control - Controls the speed of
the body fan during use.
D Body fan speed indicator - Indicates
speed of fan. (OFF - LOW - MED - HI)
E Timer display - Displays remaining time.
F Stop button - Stops tanning session.
G Timer button - Turns bed on. Timer dis-
play shows remaining time. If a lesser
time is desired, press timer button until
desired time is displayed.
WARNING
Wear protective eyewear.
Failure to may result in severe burns or
longterm injury to the eyes.