Filter
Top Products
Removal and replacement procedures 29
5.
Remove the non-hot-plug hard drive cage.
To replace the component, reverse the removal procedure.
Hard drive (non-hot-plug)
This procedure applies to non-hot-plug drives only. If the server is equipped with hot-plug hard drives,
refer to the hot-plug hard drive removal procedures ("Hot-plug SAS and SATA hard drives" on page 27,
"Hot-plug SCSI hard drive" on page 27).
To remove the component:
1. Power down the server (on page 25).
2. Remove the bezel (on page 25).
3. Remove the access panel ("Access panel" on page 26).
4. Disconnect the power and data cables.
5. Remove the non-hot-plug hard drive cage. ("Non-hot-plug hard drive cage" on page 28)
6. Remove the hard drive.